LGUP-NEW worked perfectly again after using the tool to flash the kdz. The LG Flash Tool was the only thing that worked - it didn't recognize the phone but when I started the flash it worked perfectly - However, I did have a known KDZ that I had used before a few times with LGUP-NEW when it recognized and worked before. Method 2: LG Smart Tool (on or Next Page) Easy Steps on how to flash LG K11 Plus Back to Its Factory State: You can also backup your LG K11 Plus offline without an internet connection following the steps provided here.Setup an auto or carry out a manual backup regularly of your LG K11 Plus following our guide here with data or Wi-Fi connection. I ran into a similar issue to what you're experiencing after a harder soft brick with LGUP-NEW not recognizing my phone - option 3 was my last shot before sending it in for repair. Make sure that you have the LG Mobile driver installed on your PC/Laptop before trying any of the above - it can be removed in certain instances and replaced with a generic one that doesn't allow full functioning or recognition of your device. If you bought your phone 2nd hand or it is a refurbished model, it is possible that you do not have the model you think you do - only way to be really sure is to pull the phone apart and get the model number off the motherboard. Recommended version to use.ģ) If you are using LGUP-NEW already, then your alternative will be to use the LG Flash Tool 2014 from Note: You should be very sure that you are flashing a known and proven KDZ, i.e., one preferably that you have used before with no problems, otherwise you run the risk of hard-bricking your device. 1) You can try adding Uppercut from Note: Must use LGUP version 1.14Ģ) If you are not using LGUP-NEW download from and use that version.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |